Micro Wizard finish line support, design help
I have a Micro Wizard finish "kit" without any supports...it's just the LEDs, sensors and wires. I'm going to start figuring out how to assemble this thing but wondering if anyone else has done this and can share their photos?
Discussion
Yeah...can't weld but I might try using PVC pipe for the overhead structure...not sure if it will support the LEDs though, hmmmm. I'm probably too worried about how the thing looks when I should just build whatever I need to make it work!
I say build a prototype that works, paint, checkerboard or chrome duct tape it for appearance, make a second unit if it still bugs you...
... also, 1/2" CTS .58" is a smaller outside diameter than 1/2" PVC .85" ....
but, if you need a section welded, I am available, let me know ?... go B go !
Erector set timing tower ...
[6] 6 3/8" 90*s , [2] as side rails, [2] overlapped to make the upper and [2] for the lower channels for the sensors and wires, [2 or 4] 6 3/8" straps, as uprights, [2] 1" 90*s, to attach the siderails to the up right and lower channel, [10] 10-32 screws and nuts...
if you can weld you could do this ;